一 般 介 绍：本产品是采用特殊配方和生产工艺制作的适用于中密度纤维板底材（MDF）涂装的粉末涂料，涂膜具有优异的机械性能和户内装饰性能，可广泛用于现代家具行业的表面涂装。一般不建议直接用于各种户外用品的表面涂装。
产 品 系 列：现可做成多种颜色和带金属闪光效果的砂纹或锤纹的涂层。
粉末物理性能：比重（g/cm3、25℃）:1.2-1.8粒度分布：100%小于100微米（可根据涂装的特殊要求进行调整）
固 化 条 件：120-1601（指MDF板材表面温度），20分钟。烘炉可采用普通热风循环烘箱或烘道。条件允许的最好先用红外线烘箱对刚喷好的涂层进行快加速加热流平，然后送入普通烘箱烘烤固化。
平均覆盖率：约8-9平方米/公斤，膜厚60微米（以100%的粉末涂料使用率计算）

Low temperature curing powder coatings
General introduction
This type of coating is prepared from special compositions with unique production technics,and it is suitable for the coating of moderate density fibreboard(MDF)substrate. The coating films prepared from this type of coating have excellent mechanical property and indoor/outdoor decorativeness, so the powder coating can be widely used in the surface coating for modern furniture. It is suggested not to use it directly for the coating of outdoor appliances.
Product Series
The products can be turned into sand veined or hammer veined coating layers of varioucolors or with metallic flashing effect.
Physical properties of the powder 
Density(g/cm3,25℃):1.2-1.8
Granularity distribution:100%below 100μm(it can be adapted to the specific demand of coating)
Curing Condition
 120℃ -160℃(surface temperature of the MDF substrate), 20 minutes. Ordinary hot-air cycling oven or drying tunnel can be used for the curing. The coating layer just sprayed had better be put in the infrared oven for the accelerated leveling if condition permitted, and then sent to ordinary ovens. 
Average coating rate
8-9㎡/kg, film thickness:60μm (calculated according to 100% consuming of powder coating)

Coating performance